|
Anyone
who has done any boating knows, that the measure of
enjoyment out on the water, is directly proportionate to
the dependability of the boat. No one likes it when their boat lets them down.
So, you have a new boat, and you want to keep it
looking and performing just like new.
Well, just how best can that be done?
I am sure there are many ways, but in this
section I am going to pass along our recommendations,
which we have found to be very effective in extending
the life, and improving the resale value of your boat.
1.
DO A BASIC
CHECK:
A. Make sure the drain
plug or plugs are in.
B. Check the engine and
transmission oil levels.
C. Inspect the belts
D. Look for any obvious
oil in the bilge.
E. If so equipped, look
at the water filter.
2.
PROTECT IT
FROM THE ELEMENTS:
Take two sheets of paper towel,
folded to about hand-size, and spray “303” or
equivalent upholstery UV protection product onto it.
Rub the spray over all vinyl areas before going out on the water.
This will protect the materials from Sun, soft drinks, snacks, mud and anything else that might stain.
3.
READY THE
ENGINE:
A.
Before starting the engine, either open the
engine cover, or turn on the
bilge
blower to remove any lingering fuel vapors.
B.
Then, go ahead and start it up, making sure not
to rev the engine.
Let it idle on its own. Allow it time to
gradually warm up.
Compare this warm-up
process to waking up in the morning---You don’t jump
out of bed and go to work immediately, neither should
your motor. This
warm-up cycle circulates oil throughout the block, thus,
preventing damage.
C.
After your engine warms up, take a quick glance
at all of the gauges. Make sure all appear within the
normal range.
D.
Always make sure you feel the transmission go
into gear solidly before accelerating.
4.
PUTTING
TO BED AT THE END OF THE DAY:
A.
At the end
of your cruising or skiing session, take time to dry
your boat.
You wouldn’t put
a wet horse in the barn after a long day’s run without
first drying her
off. There
is a synthetic chamois available called a water
sprite. These are
much easier to wring out than the traditional chamois,
even kids can
handle them. They
make the job of drying, quick
and
easy, and they do
an excellent job of preventing water spots from
forming on the hull
and upholstery.
B.
Remove the drain plug or plugs to let any
unwanted water out.
Be sure
to
place the plug/plugs in a spot you will remember
next time out.
C.
If at all possible, cover your boat with a custom
canvas cover.
5. GENERAL
PRECAUTIONS:
A. While
out skiing, be careful transferring the equipment from
one location
to another. Do
not drag fins or any sharp edges across the
upholstery or
fiberglass.
B. About
every four months, or more frequent, if necessary, wash
the boat
using a good cleaning product and then follow up
with a good coat of
wax on all
fiberglass surfaces.
We recommend Blue Coral Car Wash to
clean, and
Meguire’s #26 (or equivalent) to protect.
We think
you will find these procedures will extend the life of
your boat and improve its resale value in the future.
Please feel free to e-mail, fax, or call us with any
questions you may have about your boat.
We would like to make your boating experience
more fun for the entire family.
|